How to use this website

Frequently Asked Questions

Why Buy From Datsun Parts?

Customer Rewards Program

Nissan/OEM/AfterMarket Differences


Ordering, Shipping, Returns, Policies

Warranty Return Policy

Returns / Important

Parts Purchasing Department

Mission Statement

Customer / Manufacturer Quotes about Datsun Parts

Limits of Liability Statement Important Read

Charitable Giving

Gallery of Fine Cars

Cars For Sale Recommended Installers Lifetime Warranty Special Order Items From Japan Sale Items New Products Consignment Parts New Old Stock Parts Monthly Specials
Parts Category List
Axle Seals Body parts Books / Literature Brakes Brakes 1500 Brake Kits & Packages Cables Carburator R16 Carburator U20 Carburator Kits & Packages Carburator Mikuni Solex Clutch Cooling Cylinder Head G15/R16 Cylinder Head U20 Dash Differential Electrical Electrical Firing Electrical Switches Electrical Other Emblems Engine 1500/1600 Engine 2000 Engine Timing Components 2000 Engine external Engine Kits & Packages Engine Room Decals & Stickers Engine Seals Exhaust Exterior Trim Fuel Systems Front Axle Gaskets Gaskets Carburator Gaskets Engine Gaskets Transmission Differential Glass Handles & Latches Heater Interior Interior Trim Z Car Interior Fairlady 310 Interior Interior Kits & Packages Lamps & Lights Locks Knobs Mirrors Rear Axle Rubber Parts Rubber Kits & Packages Soft Tops Steering Steering Kits & Packages Suspension Suspension Kits & Packages Transmission 4 Speed Transmission 5 Speed Transmission Kits & Packages Transmission Seals Used Parts Wheels Weatherstripping Weatherstrip Kits & Packages Wiper & Washer Material & Carpet Swatches

Nissan Parts Dump

Dash Comments

Map to our location



Handles and Latches
Partnumber: 1345
Datsun Roadster & Fairlady 63 - 67 Replacement Inside Door Handle Roll Up Knob

63 - 67 replacement door handle roll up knob. (Handles not included. Shown for assembly reference only)
Hard plastic injection molded knob with internal knurled steel insert inside the plastic. Includes wave washer, flat washer, set screw and small bottle of Loc-tite
Many factory original knobs would fall off their handles because of the following questionable attachment. The original knob had a brass insert that had a swedge, variant spelling of swage, over the end of the shaft in attempt to secure the knob to the handle. Worked ok if they got the swedge right.
The original plating on the handle was not great so when re-chroming it becomes necessary to remove the knob by drilling off the swedge. After doing this there is not enough shaft left, even when attempting to install a screw, to allow the knob to rotate properly. This new alternative is much cheaper than buying a NOS handle and will last longer than the factory knob and is completely removable.

To order a Pair Order by PART# 1345PR $36.00

Copyright © 1996-2019 All rights reserved.