Shop a Movie

Customer / Manufacturer Quotes about Datsun Parts

How to use this website


Frequently Asked Questions

Why Buy From Datsun Parts?

Customer Rewards Program

Restoration Products

Nissan/OEM/AfterMarket Differences


Ordering, Shipping, Returns, Policies

Warranty Return Policy

Returns / Important

Parts Purchasing Department

Mission Statement

Limits of Liability Statement Important Read

Charitable Giving

Gallery of Fine Cars

Cars For Sale Recommended Installers Lifetime Warranty Special Order Items From Japan Sale Items New Products Consignment Parts New Old Stock Parts Monthly Specials
Parts Category List
Axle Seals Body parts Books / Literature Brakes Brakes 1500 Brake Kits & Packages Cables Carburetor R16 Carburetor U20 Carburetor Kits & Packages Carburetor Mikuni Solex Clutch Cooling Cylinder Head G15/R16 Cylinder Head U20 Dash Differential Electrical Electrical Firing Electrical Switches Electrical Other Emblems Engine 1500/1600 Engine 2000 Engine Timing Components 2000 Engine external Engine Kits & Packages Engine Room Decals & Stickers Engine Seals Exhaust Exterior Trim Fuel Systems Front Axle Gaskets Gaskets Carburetor Gaskets Engine Gaskets Transmission Differential Glass Handles & Latches Heater Interior Interior Trim Z Car Interior Fairlady 310 Interior Interior Kits & Packages Lamps & Lights Locks Knobs Mirrors Rear Axle Rubber Parts Rubber Kits & Packages Soft Tops Steering Steering Kits & Packages Suspension Suspension Kits & Packages Transmission 4 Speed Transmission 5 Speed Transmission Kits & Packages Transmission Seals Used Parts Wheels Weatherstripping Weatherstrip Kits & Packages Wiper & Washer Material & Carpet Swatches

Nissan Parts Dump

Dash Comments

Map to our location



Carburetor R16
U20 Carburator
Partnumber: 1635
Datsun Roadster & Fairlady Some Late 2000 Needle & Seat AFTERMARKET JAPAN (G/L/F)

1500/1600 some 2000's Carburetor float chamber needle & seat.OEM correct length, no modification to float arm, bolt in and go!
Below is a guide to check if anyone has monkeyed around with your float lever or if you use a different thickness float chamber lid gasket.

Correct float level should never be assumed. Use the following, Z Therapy checking method, each time you change the float needle and seats or gaskets:
Hold the float chamber lid so that the float lever arm is facing toward the ground and is fully open. Raise the arm up until the float needle closes. You can tell when it is closed if you blow threw the inlet tube and the air stops. The distance from the float arm to the bottom of the lid should be .550 of a inch. Bend the tab on the float lever arm to achieve this measurement.
$34.00 EA

Copyright © 1996-2019 All rights reserved.