Datsun Roadster & Fairlady RH Tie Rod Assembly
RARE PARTS TESTED & APPROVED AFTERMARKET NOT CHINESE
After market RH tie rod assembly. Blueprinted from Factory new Nissan parts. US engineered. Exclusive
No more expensive than the Nissan original before it went out of production.
Made by the same company that made our Rare Parts Approved upper ball joint. This company also makes parts for IMC and World Pac
NOTE Our part is marked by the manufacturer with identification numbers.
Our part is NOT the same part as the CHINESE MAIN LAND part that was offered to us to sell and refused by us because of poor heat treating, excessive ball stud pre-load, under size ball studs and .082 undersized beam thickness. (SEE PHOTO 4)
Nissan ball stud in the picture is at the top and Chinese undersized one below. Look at the area below the taper on both. The Chinese one is .040 smaller in diameter than the Nissan one above it.(PHOTO 5)
These parts did not match the Nissan samples and were deemed sub-standard and unsafe in testing. We rejected them.
OUR part does not have any of these problems or any other for that matter.
The part we sell has forging numbers in the casting
CHEAPER WHEN SOLD WITH THE LH IN PAIRS
Elliot Harvey Racing "GOOD QUALITY PRODUCTS"